OMRON

Image1

We do "File 1" using the program Sysmac Studio (OMRON). We had to understand to program in ST language and have to pass it from ST to diagram of relays language. On the left side of Image1 we can see part of the program programmed in ST language and on the other side we can see the language of relees diagram.In this tab we have created a bottle labeling program and we have managed to visualize the system on the screen. In this screen apart from observing the process, you also have a graphic of this process, possible alarms and their explanations in video or even in pdf and recipes where we can load them and change the speed of the process. We have also put the option to have different users (Supervisor, operator, administrator ...). Each user will have their own password, since depending on their function they can enter in some pages or not.

This "File2" is a classifier of pieces with different sensors to detect them. What we have had to do is that the program differentiates 3 types of pieces, although we wanted to make a recreation of "the Lord of the rings". The pieces went by a tape that was activated when an initial sensor detected piece, then the piece went to another detector where it detected what type of piece was. Afterwards, piece A(Frodo) was diverted thanks to a servomotor(Gandalf) to a conveyer belt, piece B(Gollum) was diverted to another different conveyer belt thanks to the servomotor and piece C(Sauron) returned to the back by the conveyer belt that had advanced until detecting the final sensor of piece C.After creating the program, we had to make another screen like "File1" with graphics, recipes, alarms etc... Finally, we can say that as a complication this "Card 2" had the configuration of the variable frequency drive for the movement of the conveyer belt and the programming for the drive for the servo motor.

File 2´s screen